![]() LastPatton
Registered UseriTrader: (33)
|
Blog
View LastPatton's BlogRecent Entries
Latest Blog Entry
Posted in
Tech Tips & Guides
Before we get too far past the end of the 2012 season, I would like to throw out a few tips concerning winter maintenance of our guns and gear. This by no means covers every little tip or trick that you can or should do but it definitely covers most of the basics for newer players.
Electronics
- Radios
Something that may sound like common sense but everyone forgets at some point, don't leave your radio on. Check to be sure that all of your radios are fully charged...
Electronics
- Radios
Something that may sound like common sense but everyone forgets at some point, don't leave your radio on. Check to be sure that all of your radios are fully charged...
Posted in
Airsoft Reviews
,
Tech Tips & Guides
I recently purchased a Contour ROAM to take to events. Instead of mounting it on a helment, I decided I would try it on my hat. Turns out, it works quite well, I have to adjust the position a little to reduce the amount of my hat in the picture but overall it does great.
After capturing approximately an hour of video from Op Mole Digger at Springfield, I began downloading all that video to my PC in order to edit it all.
I found that in the raw video file type was .mov...
After capturing approximately an hour of video from Op Mole Digger at Springfield, I began downloading all that video to my PC in order to edit it all.
I found that in the raw video file type was .mov...
Posted in
Airsoft Reviews
,
Tech Tips & Guides
,
GBB Pistols
So I just finished resurrecting my first GBB KWA M9 and I have to say that it looks really good.
When I got it, it was VERY dirty and you could hear the grinding of dirt in the internals. I slowly disassembled the gun getting it down to the bare bones. After some work with Fantastic and toothbrush, I was able to at least get all the gunk and grime out of the tinny places. It still looked really rough but at least it was somewhat clean. Next was to use silicon spray to lube and wash...
When I got it, it was VERY dirty and you could hear the grinding of dirt in the internals. I slowly disassembled the gun getting it down to the bare bones. After some work with Fantastic and toothbrush, I was able to at least get all the gunk and grime out of the tinny places. It still looked really rough but at least it was somewhat clean. Next was to use silicon spray to lube and wash...
Recent Comments
@Nforcer
I have...
I have...
First off, great recommendations...